Skip to main content
Armchair
Armchair

Armchair

Furniture Maker (American, working 1793 - at least 1803)
Date1796-1800
MediumBasswood, maple, ash, oak
DimensionsPrimary Dimensions (overall height x width x depth): 38 3/4 x 24 1/8 x 22 3/16in. (98.4 x 61.3 x 56.4cm)
ClassificationsFurniture
Credit LineGift of The Colebrook Historical Society
Object number1963.41.0
DescriptionDark green, painted armchair in the Windsor style, with a high back, a plank seat, and turned posts and legs. The back of the chair includes of a bowed crest rail atop seven tall spindles; the crest rail is serpentine, a shaped upper edge with an arch in the center flanked by flat scrolls. Below the crest rail is a rail that curves forward to form the flat, scrolled handholds. The rail contains the seven tall spindles and is supported at each arm by an additional short spindle and a post turned with a baluster form. The back of the armchair is slanted back; the spindles and posts are joined to the seat in a semi-circular arrangement. The basswood plank seat is shield-shaped and has a saucered, or recessed, surface with a flat area at the back where the spindles and posts join the seat. The sides and back of the plank are curved and chamfered, or cut at an angle. Below the seat are four turned legs that are raked, or slanted out from top to bottom; each is turned with a baluster form over a tapered ankle and foot. Each side of the chair has a single stretcher with an ovoid form in the center. Between the stretcher is a single medial stretcher, also with an ovoid form in the center.

Condition: The rail has completely broken through where it joins the rightmost tall spindle; this joint has been repaired with nails. The right rear side of the plank seat has either partially or completely detached from the seat and been reattached with nails or screws. The dark green paint is not original; the later paint is applied over at least one layer of lighter green paint.

Design and Construction Details: The crest rail is supported on a tenon at the top of each of the tall spindles; the center and each side spindle is also pinned to the crest rail. These spindles extend through the rail. The rail is supported on a tenon at the top of each short spindle and post; the tenon at the top of each post has a small wooden wedge through the end. The spindles are tenoned down into the spindle platform. The posts are tenoned through the spindle platform; the tenon at the bottom of each post has a small wooden wedge through the end. The plank seat is supported by a through tenon at the top of each leg; a wedge is probably inserted through the end of each tenon. The side stretchers are tenoned into the lower legs. The medial stretcher is tenoned into each of the side stretchers.
NotesHistorical Note: This chair was made by John Wadsworth, who made a large order of furniture for the Hartford State House on 8 June 1796.
Status
On view
Armchair
John Wadsworth
1796-1800
no number
Unknown
1795-1810
Side Chair
Unknown
1790-1800
Writing-arm Chair
Ebenezer Tracy
1765-1785
Rocking Chair
Unknown
1800-1815
Armchair
John Warner Barber
1785-1805
Armchair
John Wadsworth
1796-1800
Rocking Chair
Unknown
1800-1815
Armchair
Unknown
1785-1795
Armchair
Unknown
1790-1800
Armchair
Ebenezer Tracy Jr.
1803-1807